Thank you for using this Dunfield Development Systems product.

Please note that the content of this distribution is copyright, and must
not be redistributed in any way. The full text of the license agreement
is displayed during the INSTALL process.

To install this package:

From DOS/Command prompt
   - Select the drive containing the distribution.
   - CD to the subdirectory containing the distribution (if necessary)
   - Run the INSTALL program

From Windows:
   - From "My Computer", open the drive containing the distribution.
   - Locate and open the subdirectory containing the distribution.
   - Double-Click on the INSTALL program icon.

NOTE: INSTALL is menu driven, and allows you to choose what portions of
the distribution package to install, and where to put them (directory).
It will warn you before installing over an existing directory, and does
not modify AUTOEXEC.BAT or CONFIG.SYS. It simply copies/dearchives the
files from the distribution diskette into appropriate directories on your
hard disk.

Please refer to the various README.*, *.TXT, and *.DOC files installed
with the package for more information.

Note that some DDS source files ('.c', '.h' etc.) are written using tab
stops at 4 character intervals, which is much more convenient for 'C'
development than the usual MS-DOS tab stops at 8 character intervals.
The DDSIDE and EDT editors from Dunfield Development Systems correctly
support these 4 character tab stop.

For information on obtaining technical help, see the TECHSUPP.TXT file
installed with the package documentation.

Contents of this distribution:
-----------------------------------------------------------------------------
PROJECT PLANS:

    This package include all of the necessary schematics, software and
    documentation to construct the described devices (contains no hardware):

    EPROM: Stand-Alone EPROM programmer with keypad/display + RS232
        - Supports 2716, 2732, 2764, 27128 and 27256 type devices.
        - UL/DL Intel or MOTORLA formats. On-Board memory for editing.
    DBOX: Computer Control up to 8 VCRs/CAMCORDERs with CONTROL-L (LANC)
        - Control all VCR functions, reports MODE, STATUS & TAPE COUNTER
        - RS-232 serial interface to host computer.
    IR232: Serial (RS-232) controlled "learning" Infared Remote Control
        - Control any device with an I/R remote control from your computer.
        - Includes PC based "I/R code editor", and demo C program.
    RINGSWITCH: "distinctive ringing" phone line switch.
        - Directs incoming call to one of three jacks (based on ring).
        - Connects any set going off-hook to line (if idle).
        - Gives "busy" to any sets that go off-hook while line in use.
    8031DESIGN: Several 8031/8051 core system designs
        - No (0K), Shared (64K) and Separate (128K) memory configs.
        - Standard and Debug (RAM as pseudo-ROM with download).
    8051ICE: In-circuit emulator for 8051 with serial interface to PC.
        - Uses DS5000/DS2250 for true single-chip support.
        - Compatible with EMILY52 software, powerful debugging features.
    CUBIX: Complete 6809 computer system with floppy disk interface
        - Over 100 system service calls, very flexible and powerful.
        - Many application and utility programs, languages etc.
    DARC:   General Purpose Amateur Radio/Repeater Controller
    ICOM:   CI-V Computer control interface for ICOM Amateur radios.
    HTX242: Computer control RS HTX242 via Microphone data signals

